● Longitudinal track length is 2400mm , the effective cutting length is 1600mm .
●  Horizontal track width is 1200mm , the effective cutting width is 1000mm .
●  Main cutting device: 1 set, with a set of single torch and a set of automatic ignition device
●  Cutting thickness is 1～120mm .
●  Cutting speed is 50～1000mm /min.
●  Idle traveling speed: 50～3000mm /min
●  Cutting roughness is 12.5μm
●  Cutting accuracy is ± 0.5mm /M

II. Mechanical System

●  Cross beam: Single rotary structure with high strength and rigid design, and stress has been removed. The compositive compound tracks of steel mounted tracks and straight line tracks are adopted, its manufacturing accuracy is much higher than the one of steel mounted tracks, and the liable deformation of the traditional steel mounted tracks after being impacted will be overcome by using this kind of compound tracks. Racks with high accuracy are mounted, and the hardness of the teeth surfaces is produced according to the accuracy of 8-degree of GB10095-88 standard.

●  Main sliding seat: Box type welding structure, stroke spacing switch is available in the machine.

●  Main gearbox: Complete sealed and without clearance, the automatic spring clearance eliminating and wearing compensation clutch structure is available. It is high in driving accuracy, good in reliability and long in service life.

●  Tracks and racks in X direction: Racks with high accuracy that meet the requirement of DIN8523 Standard.

4.1. Tracks: Mechanical safety blocks are on both of the two ends.

a、rack: < 0.02mm

b、The tolerance of the two sides of the track: < 0.02mm

c、The perpendicularity of the two sides and top surface of the track: < 0.02mm

5、Main cutting device: 1 set, with horizontal driving deceleration box and rolling track up-and-down mechanism.

6、The cross cables are adopted with chain structure which is clean and tidy.

7、Adjustable stands for supporting the tracks.

8、Other standard and non-standard parts.

III. Control System

Intel Pentium series industrial control computer

●  9 inches of monitor
●  64M electronic disk
●  8M internal memory
●  3.5 inches of floppy drive

Functions of Control Software:

●  Automatic cutting of the whole procedure
●  Pause, acceleration and deceleration function, return and re-return function
●  Rapid positioning
●  CRT simultaneous machining display, synchronous tracking display during the procedure of machining, display of coordinate position and display of current speed
●  Changing of coordinate position
●  Acceleration and deceleration function at the turning point
●  Standard parts storage
●  Plasma interface
●  Edition language: ESA or GCD language

IV. Driving System

● Driving cabinet asse mbly
● Special master line board
● Input and output photoelectric isolation board
● Function board of cutting device
● Step-by-step motor drive unit: It can realize 5 or 10 fine steps of step-by-step motor, so high reliability is guaranteed.
● Motor: Micro step-by-step motor made in China-America joint venture enterprise

V. Gas Line System

●  Gas line case
●  Hose
●  Electromagnetic valves
●  Flashback arrester
●  Torches and tips