Weitec ICS-20 electronic belt scale, dynamic cumulative error ≤±0.5%, for the general factory belt conveyor weighing, as well as the crusher, coal mill, sieving machine and other equipment for accurate quantitative feed control, can also be used in industrial weighing process control, such as the detection of production, control of quantitative loading of products and detection of inventory and other occasions. System composition and weighing bridge: ICS-20 series belt scale is mainly composed of four parts: ICS-20 type lever weighing bridge (optional for idler), S type weighing sensor, speed measuring sensor, WTC3001 type integrator. Power supply :220 VAC,50HZ Power :50 W ICS-20 weighing bridge is equipped with a set of rollers on a single lever, with a pull sensor intermediate support, and the outer support adopts non-wear ear shaft fulcrum. This kind of sealing device can prevent shock, moisture, anticorrosion and material accumulation, so the problems caused by using knife edge device and bearing device do not occur in bad environment. The main girder of weighing bridge adopts rectangular steel pipe, which makes the whole weighing bridge have enough rigidity, small weight, and the surface ash deposit area to the minimum. no movement and breakable parts. In order to ensure the stability of the whole system, the high precision resistive strain gauge sensor is installed in the tensile position to reduce the nonlinear error. The weight scale frame can be used for the measurement of light weight material. Weighing and measuring sensors: ICS-14,ICS-17,ICS-20 series of electronic belt scales are used W9KS( original 9363) pull type electronic strain weighing sensor. Detailed indicators are ICS-14. ICS-20 series of electronic belt scale standard configuration of speed sensor using W62C-CS (original 60-12 C) speed sensoR