Symfun PoE 10/100Mbps Fiber media converter supports IEEE802.3U /100Base-Tx/Fx protocol, as well as full duplex and half duplex mode. This manual is for adaptive 10M/100M converters. Comply with IEEE 802.3af, its advanced auto-sensing algorithm enables taking power form IEEE 802..3af, Power Source Equipment(PSE) or Power over Ethernet (PoE) injector. It also supports high safety with short circuit protection and power-in auto-detection (power from AC/DC power adapter or PSE device).

• 10/100Base-TX UTP to 100Base-FX fiber media converter
• IEEE802.3af POE PD compatible.
• Provide -48VDC power to the converter through RJ-45 ETH cable
• Support MD1/MD1-X auto sensing
• Built-in DC/DC Power supply
• Optical port support dual-strand and single-strand
• Choice of SC, BIDI or LC connector from multimode/single mode
• Single mode up to 120km. Multi-mode 2km
• Technical parameters:
  1. Standard Protocol: IEEE802.3 10 Base-T standard
                  IEEE 802.3u 100Base-TX/FX standard
                  IEEE 802.3af PoE PD standard
  2. Connector:        one UTP RJ-45 connector, one SC/ST connector
  3. Operation mode: full duplex mode or half duplex mode
  4. Power supply parameter:
  --1A~2A@5V DC from AC/DC adaptor
  --60mA@48V DC from IEEE802.3af PSE or PoE injector
  5. Environmental temperature: 0℃-60 ℃
  6. Relative humidity: 5%-90%
  8. TP cable: Cat5 UTP cable
  9. Transfer fiber:
  multi-mode: 50/125, 62.5/125 or 100/140μm
  single mode: 8.3/125, 8.7/125, 9/125 or 10/125μm
  10. Dimensions: 26(H) × 71(W) × 95(D) mm