Home > Products > Electronics & Electricity > Other Electrical & Electronic

Safety:

1. Read the operating instructions before installation.
2. The ion blower shall be reliably grounded before operation.
3. Do not block the screened air inlet and outlet with any object.
4. Do not use the ion blower in flammable and explosive environment.
5. Do not repair the ion blower without permission.

Features:

1. Rapid neutralization of static charges
2. Large coverage of ion airflow
3. Wide range of airflow speed regulation
4. Dedicated cleaner for ion generating electrode
5. Ionization indicator
6. Special design on cold air & heater
7. Reliable grounding protection

Discharge Time:

1. The ion balance voltage and static charge elimination time comply with ESD standards, of which the static charge elimination time is measured at the test voltage of 1000V-100V
2. The ME268A combo electrostatic tester shall be used in the test
3. The test data will vary with the temperature and humidity of the ambient air at the time of testing

Installation:

1. The PF1205 ion blower is light-weighted and enjoys long service life. Fix the U-shaped frame with screws on the side of the blower. Tighten the screws with M8 position after the torx head screws after aligning the ion blower
2. Install the optional filter when the ion blower is used in dusty environment
3. Connect the ion blower to the 220V, 50Hz ( or 110V, 60Hz ) power supply. Insert the plug in the standard single-phase grounding socket with safety ground cable
4. Connect the power cord as follows: Brown-Phase line Blue-Neutral line Green/Yellow-Grounding line

Operation:

1. Rotate the speed regulating switch clockwise until the indicator turns on, and the ion blower is switched on to generate ion airflow. Turn up the airflow speed by turn the speed regulating switch clockwise. Turn the switch to the "off" position, and the indicator turns off, indicating that the ion blower is turned off
2. Adjust the direction of the air flow by loosening the torx head screws on the frame; tilt the ion blower to adjust the upper and lower position; tighten the screws on the frame after it is aligned
3. When the ion air needs to be heated, the ion air blown by the blower can be heated by opening the heating switch
4. Clean the ion emitter. Slide the cleaning handle left and right to thoroughly clean the ion blower
5. The ion blower produces ionized airflow covering the target area. The time required for the airflow to eliminate the static electricity is dependent on many factors, of which the two most important ones are the distance and airflow speed of the ion blower. The ions in the air are constantly neutralizing each other, and the positive and negative charges attract each other electrostatically, so the charges generated are transferred and neutralized. High airflow speeds can deliver the charges further before they are neutralized, so the higher the airflow speed, the faster it neutralizes the static electricity
6. When using an ion blower in assembly of electronic devices, cover the work area with ionized air flow as much as possible so that the positive and negative charges on the surface of the object are well neutralized, which can keeping the objects neutralized.