LT810 Solar Aviation Obstruction Light

Model:	LT810
Brand:	NANHUA
Origin:	Made In China
Category:	Consumer Electronics & Lighting / Lighting / Emergency Light & Indicator Light
Label:	solar light tower , led strobe light , obstruction light
Price:	-
Min. Order:	-

Inquire Now

Product Description

Applications

Obstruction light for a wide variety of cranes used in Harbors, Metallurgies, Towers (Telecom, GSM,Smokestacks, Buildings and any other potentially hazardous obstructions for air traffic with a steady burning red or flash safety light.

Main functions and features

• Extremely Reliable- Major Maintenance Cost Saving.

• Use NiMH battery, easy to replace.

• Lamp housing-Polycarbonate, with bird spike, with good anti-impact strength, thermal stability, high transmittance.

• Combustibility rating：UL94-V0.

Specification

International standard	ICAO(Annex 14) low intensity aviation light and FAA-L810
Light source	LED	Vertical degree	≥10°
Light color	Red	Horizontal degree	360°
Intensity	>32.5cd	Flash rate	20, 30 or 40 times/min(adjustable)，Factory setting 30/min
LED life	≥100.000h	On/off level	70/100Lux
Battery capacity	3.6V/8AH NiMH	Solar panel	4W/5V
Autonomy	7 days (at 25℃, if the ambient temperature is lower than 0℃ or above 40℃, it will affect the battery discharge)

Operating temperature	-40℃~+55℃	IP protection	IP65
Relative humidity	10%~95%	Weight	5Kg
Material	Base：Die casting aluminum Housing：PC

Installation and operation

• Mount the solar light in the most suitable place such as under direct sunlight, to ensure its continuous operation.

• Use 3 M8 screws to fasten to the mounting surface, and the surface should leveling and with enough mechanical strength.

• If operate the light for the first time, open the battery button on the bottom of light base.

• As the light has built in photocell, in case the light beam is very strong, the light will not work, when test the light, put the light in dark place.

Flashing rate adjustment

• Unscrew the fixing 6 screws.

• Disconnect the battery connection, take off the housing.

• Adjust the red switch on PCB board, and adjust the flashing rate.