LS710 Aviation Obstruction Light

Model:	LS710
Brand:	NANHUA
Origin:	Made In China
Category:	Consumer Electronics & Lighting / Lighting / Emergency Light & Indicator Light
Label:	obstruction light , led warning light , led beacon
Price:	-
Min. Order:	-

Inquire Now

Product Description

Applications

Obstruction light for a wide variety of cranes used in Harbors, Metallurgies, Towers (Telecom,

GSM), Smokestacks, Buildings and any other potentially hazardous obstructions to air traffic with a steady burning red safety light.

Main functions and features

• Use Fresnel lens, high utilization of light, valid keeping light beam in the scope as required.

• Based on LED technology, low power consumption, and high efficiency.

• Lamp housing – Polycarbonate, with good anti-impact strength, thermal stability, high transmittance.

• Die casting aluminum enclosure with powder-coat paint finishes, providing corrosion resistance and durability.

• G3/4”pipe is available, ease of mount.

• EMC Compliance, No RF Radiation.

• Self-contained compartment, with stainless steel wire which is used to secure the unit against falling in operation, and ease of mount.

• Built-in photocell can switch ON/OFF the light at dawn and dusk (optional).

• Steady burning or flashing type (no need external controller).

• Extremely Reliable – Major Maintenance Cost Saving.

• External two M20X1.5 Waterproof gland( can be customized).

Specification

Standard	Compliant to the ICAO(Aerodromes Annex 14) and FAA-L810	Vertical degree	≥10°
Light source	LED	Horizontal degree	360°
LED color	Aviation red（Other color can be customized）	Flashing rate	Steady burning or flashing(flashing rate can be selected)
Operating voltage	AC110V~AC240V	LED life	≥100,000h
Power consumption	6W	On/off level	500Lux
Intensity	≥32.5cd

Operating temperature	-40˚C ~ +70˚C	IP Protection	IP65
Relative humidity	10% ~ 95% (no condensing）	Weight	1.0kg
Material	Base：Die casting aluminum Housing: PC

Installation and operation

• Check whether the supply voltage does comply with the rated voltage of the lamp.

• Insert the power cable through the bottom of lamp holder, and connect them to the terminals in the base respectively.

• Follow connection diagram and set up work model. (remark: dial switch ON---1, figure---0)

• Tighten the screws between lamp housing and base.

• Screw the lamp on the mounting bracket, which should be fixed on a smooth surface with enough mechanical strength. Or you can select our mounting bracket: PJ024, PJ028 and PJ030 (installing diagram), special bracket can be customized.

• Switch on the power, and then the light works.